Hi there,
I’ve noticed it a few times already on different photos. The clone tool doesn’t work when you want to clone out something from an edge of a photo. See the example below:
Regards
Pawel
Hi there,
I’ve noticed it a few times already on different photos. The clone tool doesn’t work when you want to clone out something from an edge of a photo. See the example below:
Regards
Pawel
Hi Pawel
Use a tiny line very close to the edge and complete with a normal draw.
Pascal
Yes - If you take your “source” from a location parallel to the target then you’ll achieve a better result.
I agree, tho, this does need some attention for improvement.
John M
Agree, the tool does need some work. However, with experience I’ve learned how to place my masks on the edge of an image to avoid the problem,almost 100% of the time.
Mark
Thanks guys, I’ve managed to sort it out by following Pascal’s advice. The tool on the edges is very counter-intuitive.
Edges can be difficult but as you’ve found out there are ways around the tools limitations.
Mark.